iP Series Loudspe
ak
ers
8
iP Series Loudspeakers
MP = Mounting Point
MP
MP
MP
MP
MP
MP
MP
MP
Top
Rear
Right Side
Left Side
Rigging
iP Series loudspeakers may be individually flown
using a PA-A2 Eyebolt Kit, part number 0028272
[M10 × 1.5 × 37 mm forged shoulder eyebolts].
WARNING: Installation should only be done
by an experienced technician. Improper
installation may result in damage to the
equipment, injury or death. Make sure that the
loudspeaker is installed in a stable and secure way in
order to avoid any conditions that may be dangerous for
persons or structures.
Rigging Design Practices
Rigging a loudspeaker requires determining:
1. The rigging methods and hardware that
meet static, shock, dynamic, and any other load
requirements for supporting the loudspeaker from
structure.
2. The design factor and required WLL (Working
Load Limit) for this support.
We strongly recommend the following rigging practices:
1. Documentation: Thoroughly document the design
with detailed drawings and parts lists.
2. Analysis: Have a qualified professional, such as
a licensed Professional Engineer, review and
approve the design before its implementation.
3. Installation: Have a qualified professional rigger
do the installation and inspection.
4. Safety: Use adequate safety precautions and back-
up systems.
8 Fly Points [ iP-10 / iP-12 / iP-15 ]
Rigging Hardware and Accessories
Rigging our loudspeakers will invariably require
hardware not supplied by us. Various types of
load-rated hardware are available from a variety
of third-party sources. There are a number of such
companies specializing in manufacturing hardware
for, designing, and installing rigging systems. Each
one of these tasks is a discipline in its own right.
Because of the hazardous nature of rigging work
and the potential liability, engage companies that
specialize in these disciplines to do the work required.
We do offer certain accessory rigging items and some
of them may be used with a variety of products. While
these accessories are intended to facilitate installation,
the wide variety of possible installation conditions and
array configurations do not permit us to determine their
suitability or load rating for any particular application.
We are not in the business of providing complete
rigging systems, either as designers, manufacturers,
or installers. It is the responsibility of the installer to
provide a properly engineered, load-certified rigging
system for supporting the loudspeaker from structure.
Rigging Notes
The iP Series loudspeaker’s integral mounting
points are designed to support only the weight of their
own loudspeaker with suitable, external hardware.
This means that each iP Series loudspeaker must
be supported independently of any other iP Series
loudspeaker and any other loads. At least three rigging
points must be used to hang an iP Series loudspeaker.
