iP Series Loudspe
ak
ers
12
iP Series Loudspeakers
The iP Series loudspeakers have NL4 input and thru
connectors. The connectors are wired in parallel,
so use
only one of the input connectors
.
NL4
These connectors are designed to handle the higher
currents produced by amplifiers and have a locking
feature to prevent accidental disconnections. Simply
line up the tabs on the plug with the jack on the iP
Series loudspeaker, push it in and rotate it clockwise
1/4 turn to lock it in place.
NL4 Connector
Pin 1 – = Cold (–)
Pin 1 + = Hot (+)
Pin 2 – = No Connection
Pin 2 + = No Connection
+/– TERMINAL CONNECTIONS
Use a pair of wire strippers to strip 3/4" of insulation
from speaker wire. Bend the end of the exposed
copper wire into a half-circle. Turn the screws counter-
clockwise and wrap the curved wire around the
terminal with the open end towards the right (this
allows for better connection when tightening). Once
the wires are firmly attached then tighten the screws by
turning them clockwise.
+ / – Connector
COLD
HOT
1+
1+
1–
1–
2–
2+
1+
1–
Appendix B: Connections
Repair
For warranty service, refer to the warranty
information on page 15.
Non-warranty service for products is available at
a factory-authorized service center. To locate your
nearest service center, visit www.720trees.com, click
“Support” and select “Locate a Service Center.” Service
for products living outside the United States can be
obtained through local dealers or distributors.
If you do not have access to our website, you can call
our Tech Support department at 1-800-898-3211,
Monday-Friday during normal business hours, Pacific
Time, to explain the problem. Tech Support will tell you
where the nearest factory-authorized service center is
located in your area.
