MachineryHouse HAFCO METALMASTER GHD-55G, Operation Manual, Page: 63 / 134

Safety
Version 1.0.2 dated 2018-09-12 Page 62 Translation of the original instructions
DH55G GB
DH
55
G_
G
B
_
1.f
m
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the geared drill is used and maintained by personnel who are not duly qualified, there may be
a risk resulting from incorrect or unsuitable maintenance of the geared drill.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to personnel,

there may be a risk to the machine and other material values,

the correct function of the geared drill may be affected.
Always disconnect the geared drill if cleaning or maintenance work is being carried out, or is no
longer in use.
WARNING!
The geared drill may only be operated with functional safety devices.
Disconnect the geared drill immediately, whenever you detect a failure in the safety
devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices. This is your responsibility as the operator!

"Safety devices“ on page 64
1.6 Qualification of personnel
1.6.1 Target group
This manual is addressed to

the operating companies,

the operators,

the maintenance personnel.
Therefore, the warning notes refer to both, operation and maintenance personnel of the geared
drill.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
Always disconnect plug of the geared drill from the electrical power supply. This will prevent it
from being used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. The operator may only carry out tasks that exceed normal
operation if this is stated in these instructions and the operating company has explicitly
entrusted him with the task.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.