Macherey-Nagel NANOCOLOR VIS II, Quick Start Manual

Page: 23 / 33

23 Quickstart guide NANOCOLOR ®
UV
/
VIS
II / VIS II V 1.02 / 08.15
6.2 MN tests
6.2.1 Tube tests
With the spectrophotometer MACHEREY-NAGEL tube tests can be selected in
different ways. All test tubes are labeled with a barcode. When the start screen
is active or the device is in measuring mode, the barcode of the inserted test
tube will be scanned automatically. The instrument detects the tube test and the measur-
ing process is initiated automatically (tube tests which need to be measured against a
zero solution cannot be measured automatically).
After the measurement has been completed, the measurement result will be displayed
in the result window. Via and the icons below the result window, different sample
information can be added. Removal of the cuvette or leaving the menu via the remainder
of the task bar icons quits the measurement process and stores the measurement result
in the measurement memory of the device.
UV/VIS II
Open Mode, 28.10.2014, 10:57
Measure Zero 0010 Sample author Sample
place
Comment
49 mg/L Mg
86 mg/L Ca
> 25 °e (29.2)
0444 Hardness Ca / Mg
540 nm
86 mg/L Ca
0.567 E
IQC
Fig. 17: Result
In addition to opening the measurement menu through barcode identification, in the test
menu it is possible to manually select the tube test from a list through or to manually
insert the test number through
1 2 3
4 5 6
7 8 9
.
In case of these two options, the measurement will not be triggered automatically after
insertion of the test tube. In these cases you can initiate the measurement by pressing
.