36
EN
180°
Fig. 11
PERFORMING THE SHARPENING
8
.2 - Versions with built-in sharpener
WARNING: Cutting hazard! Use protective cut- and tear-
resistant gloves and perform all operations with extreme care.
PAY ATTENTION AT ALL TIMES !
For the blade sharpening to be performed periodically as soon as a decrease in the
cutting capacity is felt, it necessary to observe the following instructions:
1. Accurately clean the blade (11) with denatured alcohol in order to degrease it after
disconnecting the plug from the power socket;
2. Loosen the knob (20a), lift and rotate the sharpening appliance (20) by 180° and
insert the wheels on the slicer blade. Relock the knob (20a);
20a
20a
20
20
11
20
20
20
11
11
11
37
EN
Fig. 12
Fig. 13
30÷40 sec.
3÷4 sec.
PERFORMING THE SHARPENING
3. Start the switch (1) and press the button (x2);
4. Let the blade rotate for about 30/40 seconds, then stop the blade by operating the
switch (1) and, with a slight shift (using a pencil) to the outside of the blade, check
if some burr has formed;
We recommend to perform this checking very carefully as
it is a very sharp body.
5. Ascertained the formation of burr, operate the switch (1) for 3/4 seconds again by
pressing the buttons (x2 and x3) at the same time;
☞
DO NOT EXTEND THIS OPERATION BEYOND THE ABOVE
MENTIONED FEW SECONDS TO AVOID THE HARMFUL
TORSION OF THE BLADE WIRE.
x2
x3
x2
403003 G21E
30/47
