MacDon TM100, Manual

Page: 82 / 198

262150
68
Revision A
1034539
A
B
Figure 4.54: Center-Link
12. Using the tractor SCV controls, adjust the length of center-
link (B) so the attachment hole aligns with the header
bracket hole.
NOTE:
This operation will work only if power is connected to the
console in the cab.
13. Shut down the engine, and remove the key from the
ignition.
14. Secure the front of center-link (B) with retained clevis
pin (A). Secure clevis pin (A) with the lynch pin.
CAUTION
Always connect the center-link before fully raising the header.
DANGER
Ensure that all bystanders have cleared the area.
15. Start the engine and slowly raise the float module using the
tractor SCV controls while ensuring the float module arms
engage the header legs.
16. Raise the header to its full height, stop the engine, and
remove the key from the ignition.
1034470
A
Figure 4.55: TM100 Lift Cylinder
17. If the header is uneven when lifting, rephase the cylinders
as follows:
a. Extend lift cylinders (A) and hold the SCV control until
both cylinders reach maximum and equal extension.
b. Retract lift cylinders (A) and hold the SCV control as
necessary until both cylinders reach equal retracted
length.
NOTE:
This procedure allows the cylinders to rephrase to ensure
even lift in operation.
ATTACHING AND DETACHING TRACTOR MOUNT FLOAT MODULE