214367
28
Revision A
3.10
Installing Forming Shield
To install the forming shield, follow these steps:
1.
To ease forming shield installation, remove header from windrower (if attached). Refer to your windrower
operator
’
s manual for instructions.
1009324
A
B
C
D
Figure 3.42: Attaching Plate to Windrower Leg
2.
Retrieve plate (A) and attachment hardware from
forming shield bundle.
NOTE:
Hardware is supplied with forming shield bundle.
3.
Attach plate (A) to windrower leg with two 1/2 x 5-1/4 in.
hex bolts (B) and nuts. Repeat for opposite leg.
IMPORTANT:
Plate (A) is shown in standard position. If installing
double windrow attachment (DWA), install plate in
inverted position.
4.
Install a 1/2 x 4 in. hex bolt (C) with spacer (D) and nut
on each plate. Hardware is supplied with forming shield
bundle.
1006026
A
Figure 3.43: Clevis Pin at Forward End of
Forming Shield
5.
Remove the two clevis pins (A) from forming shield
forward end.