214497
21
Revision D
3.8
Removing Outboard Rock Guards
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
Before installing the cutterbar, remove the outboard rock guards as follows to simplify installation.
1027053
A
B
C
Figure 3.31: Left Outboard Rock Guard
–
View
from Rear
1.
Locate rock guard (B) on the bottom outboard end of the
cutterbar. There is one guard on each end of the cutterbar.
2.
Remove the two hex head screws (A), washers, and lock
nuts (C) securing rock guard (B) to the cutterbar assembly.
1027241
A
B
C
Figure 3.32: Left Outboard Rock Guard
–
Side View
3.
Remove bolt and washers (A).
4.
Loosen bolt (B).
5.
Remove rock guard (C) by sliding it forward.
6.
Repeat Steps
to
at the opposite side
of the cutterbar.
