214497
17
Revision D
3.4
Removing Cutterbar Deflectors
The cutterbar deflectors are used with roll conditioners only.
1024787
A
C
B
D
Figure 3.24: Cutterbar Left Deflector Viewed from
Underside of Cutterbar
1.
Locate deflector (A) on the back of the cutterbar.
2.
Clean debris from deflectors and deflector area.
3.
Remove bolt (C) shared with the rock guard from the
cutterbar on the outboard end of deflector. Retain the
hardware.
4.
Remove three bolts (B) and nuts securing deflector (A) to
the cutterbar using an 8 mm hex key and a 17 mm socket.
Remove deflector (A). Retain the hardware.
5.
Repeat previous steps for deflector (D) on the opposite side
of the header.
