MacDon M205 2010, Operator'S Manual

Page: 91 / 221

HEADER – GENERAL
Form 169469/169470/169471
89
Revision C
2. If the header is below the pre-set height,
press and hold the HEADER UP switch to
raise the header. Release switch to stop
header. Alarm will sound when header rises
past the pre-set height.
3. If the header angle is changed, double click
(two clicks within 0.5 seconds) the HEADER
TILT UP or HEADER TILT DOWN switch
and the header will return to the pre-set
angle.
NOTE
If the header cannot return to the pre-set
height or angle within 30 seconds, the
RETURN TO CUT feature will deactivate
to prevent the hydraulic oil from
overheating. Push the RETURN TO CUT
switch to reactivate.
6.4.6.2 Auto-Raise Height
a. Program the AUTO RAISE HEIGHT feature as
follows:
1. RETURN TO CUT switch can be off or on.
2. Press PROGRAM and SELECT on CDM to
enter programming mode.
3. Press SELECT. TRACTOR SETUP? is
displayed on upper line.
4. Press , then SELECT. SET KNIFE
SPEED? is displayed.
5. Press SELECT until AUTO RAISE HEIGHT
is displayed.
6. Press or to change value on
lower line. Range is 4.0 to 10.0 where 10.0
is fully raised.
7. Press PROGRAM to exit programming
mode when finished entering desired values.
b. Use the AUTO RAISE HEIGHT feature as
follows:
IMPORTANT
The windrower must be running with the
header engaged at the cutting height and
the RETURN TO CUT switch activated.
1. Double click HEADER UP switch on the
GSL to raise the header to the AUTO RAISE
HEIGHT set point.
NOTE
If HEADER UP is pressed while header is
being raised, AUTO RAISE HEIGHT is
temporarily disabled and header will
maintain current height.
NOTE
With AUTO RAISE HEIGHT off, the ACRE
counter will be disabled when header
height value is >9.5. OFF is displayed on
the CDM.
2. Momentarily press the HEADER DOWN
switch on the GSL to return the header to
the pre-set cutting height.
6.4.6.3 Header Drop Rate
The header should lower gradually when the
HEADER DOWN switch is pressed. From full
height to ground should take approximately 3.5
seconds. If the drop rate requires adjustment,
refer to Section 7.11.5.3 Header Drop Rate, in
MAINTENANCE/SERVICE.
HEADER DOWN
RETURN TO
CUT
DISPLAY
HEADER UP