215505
28
Revision A
Center disc and tail end bushings
$
%
Figure 5.9: Cam End
14. Position bushing halves (B) on tine tube (A) with the
flangeless end adjacent to the tine tube arm, and position
the lug in each bushing half into the hole in the tine tube.
15. Slide tine tube (A) onto bushing (B) and position against the
disc at the original location.
$
%
Figure 5.10: Tine Tube
16. Slide the new finger and tine tube arm (A) onto the end of
the tube.
17. Attach the fingers to the tine tube with bolts and nuts (B).
For finger location and proper hardware installation refer to
3 Steel Finger Placement, page 9
18. Torque steel finger hardware to 35 Nm (26 lbf·ft).
NOTE:
Do NOT overtighten hardware, may result in flattening of
tube.
$
%
Figure 5.11: Bushing
19. Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
20. Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
