LIGHTS
Form 147398
28
Revision J
B. INSTALL LIGHT WIRING
HARNESS
I. D60, FD70 HEADERS
a. Retrieve wiring harness from transport kit.
b. Run a piece of fish tape or wire (A) through the
front of the arm and route it to the rear as shown.
c. Attach it to the square connector end of the
harness (B).
d. Pull wiring harness (B) up inside reel support arm
to light at end of arm. Remove the fish tape or
wire.
e. Connect harness (B) to light at connector (C).
IMPORTANT
Route wire exactly as shown, otherwise it
will get damaged by crop at low reel
positions.
NOTE
Wire colours do not match up when
connecting harness to lights. Refer to
wiring schematic on page 14.
f. Secure harness (B) at end of arm with clip (D) that
was
removed
from
endsheet
and
a
3/8 NC X 1.0 LG carriage bolt (E) and nut.
A
B
E
C
B
D
