Before you start
Unpacking and assembly
For storage and transport purposes, some components of the machine are not installed in
the factory and have to be assembled after unpacking. Follow the instructions below.
IMPORTANT
The machine is supplied without engine oil or fuel. Before starting up the en-
gine, fill with oil and fuel following the instructions given in the engine manual.
WARNING!
Unpacking and completing the assembly should be done on a flat and
stable surface, with enough space for moving the machine and its packaging, always making
use of suitable equipment.
UNPACKING
When unpacking the machine, take care to gather all individual parts and fittings, and do
not damage the cutting-means assembly when taking the machine off the pallet.
The standard packaging contains:
– the machine;
– dashboard cover;
– steering wheel column caster;
– the steering wheel;
– the seat;
– cutting means engagement control lever extension;
– the grass catcher components;
– the lower part of the back plate;
– “mulching” attachment components (if provided);
– the side discharge chute (if provided);
– equipment to be used to complete assembly of the various machine components (in
separate bags for each use);
– a battery charger (if provided);
– 2 starter keys;
– a spare 10 A fuse, to be kept in case of necessity.
– Instructions manual and machine documents.
NOTE
To avoid damaging the cutting-means assembly when getting the machine down
from the pallet, take it to the maximum height and be very careful.
Hydrostatic transmission
To make it easier to get the machine off the pallet and to move it, the rear drive disen
-
gage lever should be put in position «B»
(
page 22, section 23.).
Disposal of the packaging should be done in accordance with the local regulations in force.
14
TTK550LWM by TITAN
GB
IE
Getting
star
ted
...
