+1 888 818 2814
Page No.15
14
Electrical i
instructions with house battery bank, DC to DC
Once your unit is installed you will need to connect the unit and electrical
system properly.
Components required for a ba�ery bank installa�on include a
DC-to-DC
charger, 100 Amp Breaker or in
-line fuse (
not recommended),
Lithium
Iron
ba�eries, and
4-gauge
wire positive
and nega�ve for connections
ample length to reach the unit and
alternator.
A/ Mount your DC-to-DC
charger and
Lithium Iron
ba�eries in the
desired loca�on securely. Then connect your posi�ve and nega�ve
terminals to the
engine ba�ery or
alternator and run them to the
positive and negative terminals of the DC-to-DC
charger.
B/ From the DC-to-DC
charger you will run the cables to a breaker
. Ideally
that breaker will be 100 Amps to protect that circuit from potential over
voltage.
C/ You
will run your wires from your breaker to the
Lithium Iron
ba�eries.
ELECTRICAL INSTALLATION INSTRUCTIONS WITH HOUSE
BATTERY BANK, DC TO DC CHARGER, AND VEHICLE
ALTERNATOR IF APPLICABLE
+1 888 818 2814
[email protected]
www.MabruRV.com
+1 888 818 2814
[email protected]
www.MabruRV.com