Clear The Flash Icon And Melody Sound:
While triggering the alarm, the LCD screen will
alert the user through melody sound and flashing trigger icon. Pressing
button 3
times within 3 seconds will clear the flash icon and stop the melody sound on the LCD
screen transceiver.
Stop The Melody Sound Only:
While triggering the alarm the LCD screen will alert user
through melody sound and flashing trigger icon. Press any button on the LCD remote
transceiver to stop melody sound only.
NOISE ABATEMENT CIRCUIT:
Your system has “Noise Abatement Circuit”. It prevents
annoying repetitive trigger sequences due to faulty sensor or environmental condition
such as thunder, jackhammers, airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm (full trigger) triggers five times
while warn-away trigger triggers 20 times. Each time the same sensor or switch is
triggering the alarm, “Noise Abatement Circuit” will interpret this pattern of triggers as
false alarm. After the fifth trigger of full trigger or 20
th
trigger of warn-away trigger, “Noise
Abatement Circuit” ignores, or by-passes that sensor or switch until the other sensor or
switch is triggered.
This feature is not applicable to the Tilt Sensor.
O. SYSTEM’S TRIGGER CHECK
(For two-way transceiver operation only)
Press the transceiver
button first, within 3 seconds, press
I
(C)
button. It
responds with one melody sound and all trigger’s records will immediately be
displayed on the LCD screen.
P. DRIVER PAGING / OST AND FOUND
(For two-way transceiver operation only)
It is useful in the event that someone wants to page the driver of the parked
motorcycle or someone cannot find his LCD motorcycle remote transceiver.
When disarmed, press and hold the Valet switch for 2 seconds to page the dr
iver.
One chirp sound shall be emitted from the motorcycle and the paging melody
sound continues sounding from your Remote LCD transceiver and “
” indication
flashes on the LCD screen.
Q. CHANNEL 3 TIMER CONTROL OUTPUT.
Press and hold button on transmitter for two
III
seconds to remote control the channel 3 output.
Channel 3 is user-programmable timer output. You may program the built-in timer to send a
ground signal / latch / latch with ignition / 30 seconds/ 60 seconds/ 90 seconds timer output.
Note1: Factory default setting at 1 second pulse grounded output.
Note2: Upon activating channel 3, the siren/horn will emit one chirp to indicate channel 3 is
latched on or emit two chirps to indicate channel 3 is latch off.
R. CHANNEL 4 TIMER CONTROL OUTPUT
Press the transmitter and buttons at the sa
I
III
me time to active the Channel 4 function.
Channel 4 is user-programmable timer output. You may program the built-in timer to send a
momentary / latch / latch with ignition / 30 seconds/ 60 seconds/ 90 seconds timer output.
Note1: Factory default setting is momentary output
.
Note2: Upon activating channel 4, the siren/horn will emit one chirp to indicate channel 4 is
latched on or emit two chirps to indicate channel 4 is latched off.
S. POWER ON MEMONRY
This security system is equipped with circuitry that will allow the unit to remember its alarm state
if the power is lost and then reconnected.
T. POWER SAVE MODE FOR MOTORCYCLE’S POWER
If the motorcycle is not driven within 12 hrs or the security system doesn’t activate by remote
control within 12hrs, the security system will automatically turn on power save mode. While in
power save mode, the security system uses approach “0” current to save the motorcycle’s
battery power.
When the system is in power save mode, all remote control and shock sensor function are
bypassed, however the ignition trigger / wire loop trigger / instant trigger / starter interrupt feature
8