EXIT: Press and hold the
button for 2 seconds or leave it for 10seconds, the system will exit
the programming mode.
1. Timer Setting: Example to AM10:30
1. Press & hold
button for 3 seconds, with two-melody sound, the “Hours” digit will flash for
adjusting.
2. Press
IV
or
III
button to decrease or increase the “Hour” digit until AM
10
:xx.
3. Press
button once again then the “Minute” digit flashes for adjusting.
4. Press
IV
or
III
button to decrease or increase the “Minutes” digit until AM 10:
30
.
5.
Press
button for 2 seconds with one-melody sound will confirm exit of the timer program
mode.
2. Alert Alarm Timer Setting: Example to PM 6:30
1. Press & hold
button for 3 seconds, with two-melody sound, the “Hours” digit will flash for
adjusting.
2. Press
button twice, the LCD screen will show
icon and “Hours” digit will flash for
adjusting.
3. Press
IV
or
III
button to decrease or increase the “Hour” digit until
PM 6:xx
.
4. Press
button once again then the “Minutes” digit flashes for adjusting.
5. Press
IV
or
III
button to decrease or increase the “Minutes” digit until
PM 6:30
.
6. Press
button once again then
icon flashes for alert alarm “ON / OFF” setting.
7. Press
III
button to start the “Alert Alarm Timer”, and the “ON” icon will show on the LCD
screen.
Press
IV
button to stop the “Alert Alarm Timer”, and the “OFF” icon will show on the LCD
screen.
8.
Press
button for 2 seconds with one-melody sound to confirm exit the timer program
mode.
3. Count Down Timer Setting: Example Set count down timer at 2:30
1. Press & hold
button for 3 seconds, with two-melody sound, the “Hours” digit will flash for
adjusting.
2. Press
button 5 times, the LCD screen will show
icon and “Hours” digit is flashing for
adjusting.
3. Press
IV
or
III
button to decrease or increase the “Hour” digit until
2:xx
.
4. Press
button once again then the “Minutes” digit flashes for adjusting.
5. Press
IV
or
III
button to decrease or increase the “Minute” digit until
2:30
.
6. Press
button once again then the
icon will flash for alert alarm “ON / OFF” setting.
7. Press
III
button to start the count down timer, and the “ON” icon will show on the LCD screen.
Press
IV
button to stop the count down timer, and the “OFF” icon will show on the LCD
screen.
8. Press
button for 2 seconds and one-melody sound will confirm exit of the timer program
mode.
Note:
Maximum timer mode is 24 hours.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE
1. Avoid environment hazard, please do not start engine inside
garage.
2. Avoid pressing remote transmitter unnecessarily.
3. Use new battery n remote transmitter for better operation. If
reception get weaken.
4. Read Manual carefully.
12