1. Turn the ignition switch to the 'ON’ position. (Alarm will sound.)
2. Press the Valet switch the selected number of times (1-9 presses) within 15 seconds. (By
pressing the Valet switch, the system's siren will stop alarming and the parking lights will stop
flashing but the motorcycle cannot be started and driven away until you disarm the system.)
The system should now be disarmed. If it is not, you may have waited too long to press the Valet
switch. Turn the ignition off and on and try again.
K. VALET MODE: (System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm function are bypassed, however the remote panic feature and Channel 3 / 4 will
remain operational. To use the valet mode, the system must first be disarmed either by using
your remote transmitter, or by operating the Manual override sequence.
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The LED will
remain on as long as the system is in ‘valet mode’.
Exit Valet Mode:
1. Return to normal operation, turn ignition ‘ON’.
2. Push and hold valet switch for 2 seconds; The LED will turn off, indicating that
the system has exited the valet mode.
REMOTE VALET: (System in Disarm or Valet mode)
Press and release the
III
button three times within 3 seconds to enter / exit valet mode.
A parking lights flash will confirm entering the valet mode.
Two parking lights flashes will confirm exit.
L. MOTORCYCLE LOCATOR
Press
IV
button on the 5-button 2-way transceiver in armed mode to activate the motorcycle
locator function. The siren will chirp 6 times and the parking lights will flash 12 times, for you to
easily locate your motorcycle.
M. PANIC FUNCTION
The transmitter can be used as a remote panic switch to manually trigger the
alarm in case emergency. To activate the panic mode, pressing and holding
I
or
IV
button of your transmitter for 3 seconds. The siren will sound and continue for 30
seconds or until
I
or
IV
button is activated a second time.
N. TRIGGER THE SYSTEM
When armed, your motorcycle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.
2. Heavy impacts will trigger the system. The full trigger sequence is 30 seconds of constant
siren and flashing parking lights.
3. If the tilt switch is triggered / the closed loop wires of the connection are not in contact / the
ignition is turned on while the system is armed, the full trigger sequence will activate.
4. The starter kill prevents the motorcycle’s starter from cranking.
Activated on the
Tilt Sensor
Activated on the
Close Loop
Activated on the
Shock Sensor
Activated on the
Ignition Switch
Warn-away
Trigger
7