Lightcommander 24/6 - 48/6
Lightcommander 24/6 - 48/6
Lightcommander 24/6 - 48/6
Lightcommander 24/6 - 48/6
Lightcommander 24/6 - 48/6
eMail: [email protected] . Tel.: +49 9 31 49 79 40 . User's Manual Lightcommander 24/6 - 48/6
37
37
37
37
37
7.2.3. Theatre Sequence
There are two special modi for Theatre Sequences available with only a little
difference. In general every sequence receives within both modi a step name
consisting of numbers instead of a step number. This name will be unchanged
while inserting or deleting steps. So step 1. 1 will be created by inserting a new
step between step 1 and 2.
Especially in theatre this is the usual mode to insert or delete additional steps
without changing the whole concept.
The Theatre Mode is selected resp. shifted by pushing
Selecting this mode all previous sequences were deleted after an additional
enquiry.
Therefore it is absolutely necessary to choose either the theatre sequence or
the "normal" sequence before programming the desk!
At any time it is possible to switch between mode 1 and 2 without data getting
lost. To switch from mode 2 back to mode 1, answer "NO" to the enquiry "are
you sure?". So also the sequences are not lost.
The sequences in mode 1 are programmed in the same way as described in
Chapter 5 (p. 23).
In mode 2 either the actual output (LIVE) or the actual step (BLIND) will be
stored.
Firstly the full step name is given (for example 1.0, 2.0, 3.0...); this name can
later be changed within the second PROGRAMMING SEQUENCE menu (after
pushing ENTER once) after turning off INFADE and OUTFADE.
Without changing the step name there is a standard step distance of 1.0. There-
fore nine steps (X.1 to X.9) can be inserted; this is done automatically by IN-
SERT. Because changes can be made only within the previous and following
step, a rising order appears.
UTILITY/
SETUP
SETUP
THEATRE
SEQUENCE
IMPORTANT !
