Industrial HMI Touch Panel Hardware Manual
M2I Corporation
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr
20 / 22
(2) I/O Terminal Block’s wiring of Pin Terminal
B
F
D
AWG Spec.
Available Range
1.1 ~ 1.5mm
8 ~ 10mm
3mm or less
26 ~ 20
Recommended Spec.
1.5mm
10 mm
20
(3) Wiring of power is as follows.
8.2 Ground Wiring
1) The product has enough anti-noise measure, so except that there are many noises.
Specially, the ground is not needed. When doing ground, please refer to the followings.
2) The ground should be the exclusive ground. The ground should be type Class 3 ground. (Ground resistor is
less than 100Ω.)
3) When you cannot do the exclusive ground, do common ground like figure B).
(4) Use the cable more than 4mm
2
. Put the point of the ground near product and shorten ground line.
A)
Exclusive ground
B)
Common ground
C)
Common ground
