M Vision CINE 400-3D, Service Manual, Page: 14 / 82

01
Inlet NTC thermal sensor is over temperature
–
Inlet NTC thermal
sensor is over temperature. Temp. is over spec. Check and
replace Inlet thermal sensor
03
Lamp 1 over temperature
–
Lamp over temperature. Check and
replace Lamp1 thermal state
a). To wait the cooling Mode finished.
b). To check the thermal sensor if shorted.
07
Ballast 1 over temperature
–
Ballast is over temperature. Check and
replace Ballast thermal state
a). To check if all fans are working.
b). To wait the cooling Mode finished.
c). To read back the ballast temp through serial interface
(DB9 connector).
20
Fans initial error when system power on
–
Fans error when system
power on. Anyone fan could be error when power on. Thus,
check and replace error fan you find out.
21
Fan1 locked
–
Fan1 locked and Fan1 get error during projector
working. Check and replace fan 1
22
Fan2 locked
–
Fan2 locked and Fan2 get error during projector
working. Check and replace fan 2.
23
Fan3 locked
–
Fan3 locked and Fan3 get error during projector
working. Check and replace fan 3.
24
Fan4 locked
–
Fan4 locked and Fan4 get error during projector
working. Check and replace fan 4.
25
Fan5 locked
–
Fan5 locked and Fan5 get error during projector
working. Check and replace fan 5.
26
Fan6 locked
–
Fan6 locked and Fan6 get error during projector
working. Check and replace fan 6.
27
Fan7 locked
–
Fan7 locked and Fan7 get error during projector
working. Check and replace fan 7.
28
Fan8 locked
–
Fan8 locked and Fan8 get error during projector
working. Check and replace fan 8.
29
Fan9 locked
–
Fan9 locked and Fan9 get error during projector
working. Check and replace fan 9.
40
Lamp ignited fail 3 times when system power on
–
Lamp ignited fail 3
times when system power on. Check and replace ballast and
power board.
a). To check the ballast control cable between Ballast and