M Vision CINE 400-3D, Service Manual, Page: 11 / 82

.
22
Fan2RatateError
––
Fan2 locked, Fan2 get error during projector
working. Check and replace fan 2
23
Fan3RatateError ––
Fan3 locked, Fan3 get error during projector
working. Check and replace fan 3.
24
Fan4RatateError
––
Fan4 locked, Fan4 get error during projector
working. Check and replace fan 4.
25
Fan5RatateError
––
Fan5 locked, Fan5 get error during projector
working. Check and replace fan 5.
26
Fan6RatateError
––
Fan6 locked, Fan6 get error during projector
working. Check and replace fan 6.
27
Fan7RatateError
–––
Fan7 locked, Fan7 get error during
projector working. Check and replace fan 7.
28
Fan8RatateError
–––
Fan8 locked, Fan8 get error during
projector working. Check and replace fan 8.
40
LampInitFail
–
Lamp ignited fail 3 times when system power on.
Check and replace ballast and power board.
a). To check the ballast control cable between Ballast and
Micro controller BD.
b). To check the Lamp
c). To check the power cable of Ballast
41
LampLitFail
–
Lamp shut down while system is working. Check
and replace lamp.
a). To check the Lamp
b). To check the fans
42
Ballast1UartError
–
Ballast UART communication fail. Check
and replace ballast and power board.
a). To check the ballast control cable between Ballast and
Micro controller BD.
b). To check the ballast
50
InterLockOpen
–
Lamp door was opened. Check the lamp door
a). To check the Lamp door.
b). To check the cable between Interlock BD and Micro
Controller BD.
51
AirFilterError
–
Check and replace air filter.
60
DMDInitFail
–
DDP3021 communication fail when system power
on. Check and replace DMD chip, DMD board, W2 board,
Ballast, and Power board