To use Speed controller
1.Turn No.13 dial on the rear side to set the required speed.(No.12)
Note:
1)Speed is controlled from 100 to 1500 rpm by the dial.
(Turn the dial clockwise, then speedis increased 10 by 10 rpm, and turn the dial counter clockwise,
then speed is decreased 10 by 10 rpm)
2)To stop the speed, turn the dial counter clockwise till the end.
3)Set the required speed by dial, then it will arrive at the setting value in a few second and keep the
constant speed by arithmetic logic unit.
(Smooth start function)
4)In initial operating, if the motor does not run, give the motor output fast and make it run until speed
is arrive at 10rpm so that the motor runs.
※ When "Err" are shown on display
① Check if the temperature sensor is coneected corretly.
② Check if the wire of the temperature sensor is not down.
③ Check if the tempereture sensor is broken.
④ Check the position of sensor in the sensor switch, internal or external sensor.
( It is same situation with No.1 case )
[] If you have any other questions, contact Misung or Misung authorized distributor in your country.
