TR3EX
P. 4 / 7
EM-8632
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
SETTING & CHECKING
1) IP ADDRESS
The R3-NE1 does not support BootP Table Software. The IP Address can be configured by using the R3CON Configurator
Software.
The Modbus/TCP Port No. is fixed to 502.
2) DATA ALLOCATION
Data Allocation Type must be assigned to each I/O module position to specify how many data areas (four types) are to be
occupied by each.
Two bits from SW1 and SW2 are assigned to each position on the base.
3) CHECK WIRING
Connect an Ethernet cable to the front RJ-45 jack.
4) CHECK LED
When wiring is correct, LINK and LINK10, or LINK and LINK100 are turned on.
When the module is receiving or sending data, LINK10 or LINK100 blinks.*
* For firmware version V3.00 or later, LED turns ON.
5) CHECK R3-GE1 CONNECTION
Enter “ping command” on the Windows MS-DOS as follows:
C:¥WINDOWS>ping ***.***.***.***
(***.***.***.***: Enter IP address in decimal.)
ping ***.***.***.*** with 32 bytes of data:
Reply from ***.***.***.*** : bytes=32 time<10ms TTL=64
Reply from ***.***.***.*** : bytes=32 time<10ms TTL=64
Reply from ***.***.***.*** : bytes=32 time<10ms TTL=64
Reply from ***.***.***.*** : bytes=32 time<10ms TTL=64
Ping statistics for ***.***.***.***
Packets:Sent=4,Received=4,Lost=0(0% loss)
Replies in case of normal connection are as shown above. If the connection cannot be established normally due to e.g. wrong
IP address, other replies such as “time over” will be received.
6) CHECK CONNECTION TO THE APPLICATION SOFTWARE
Check Point 1:
LINK LEDs
When a normal connection is established, the front LINK and LINK10 or LINK100 are turned on regardless of data send-
ing/receiving status. Check power supply to the hub in case that these LEDs are not on.
Check Point 2:
RUN Indicator LED
With the side DIP SW3-4 is set to OFF, the RUN Indicator LED turns to Green in normal data sending/receiving.
Check Point 3:
Sending/Receiving Indicators
With the side DIP SW3-4 is set to ON, the RUN Indicator LED turns to Red in data receiving, and the ERR Indicator LED
turns to Green in data sending. In normal operating conditions, these LEDs may seem to flash at once due to the high speed
transmission.
