M2EXS
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax:
+81(6)6659-8510 E-mail: [email protected]
EM-5137-B Rev.1 P. 6 / 18
■
OPERATION IN EACH SETTING MODE
•
Basic operation
Mode Button:
In measuring mode, holding down Mode button for ≥ 2 seconds, ≥ 4 seconds, ≥ 6 seconds or ≥ 8 seconds
enables to move on to each setting mode. Holding down Mode button for ≥ 2 seconds at each setting item
display enables to return to measuring mode.
Holding down Mode button for ≥ 2 seconds while changing settings (‘(Setting)’ is displayed next to ‘DATA’)
enables to discard setting value in changing, and to return to the state before change settings (‘(Setting)’
next to ‘DATA’) is off).
Set Button:
Pressing Set button at each setting parameter enables to blink setting value and changing settings is
ready (‘(Setting)’ is displayed next to ‘DATA’). Pressing Set button while changing settings enables to
enter (save) setting value and change from blinking to on.
Up Button:
Press Up button to move through setting parameters. Selecting setting value while changing settings,
increasing a setting value to set value. Keeping pressing Up button enables to increase the value
continuously.
Down Button:
Press Down button to move through setting parameters. Selecting setting value while changing settings,
decreasing a setting value to set value. Keeping pressing Down button enables to decrease the value
continuously.
•
Operation of input setting parameter
[06] Angle offset is set by teach.
The present input value is displayed by pressing set button. With input value desired as 0% is entered, pressing set button
again enables to fix the setting.
[07] Angle span sets width used.
Angle for 0% = [06], angle for 100% = [06] + [07]
•
Input / output scaling setting parameter
For input/output scaling setting parameter, set values digit by digit. Pressing Set button enables to move blinking digit.
Adjust blinking digit to set numerical value with Up and Down button. Blinking digit moves from most significant digit with
pressing Set button. At least significant digit, pressing Set button again enables to turn on and determine the setting value.
During setting, press and hold Mode button for ≥ 2 seconds to discard the setting value.
ITEM
14
DATA
0
0%
input scal
ITEM
14
DATA (Setting)
0%
input scal
ITEM
14
DATA (Setting)
0%
input scal
ITEM
14
DATA (Setting)
0%
input scal
Set button
Set button
Set button
Setting sixth digit
Setting fifth digit
Set button (save)
Setting first digit
000000
000000
000000
•
Lockout setting
‘Lockout setting’ is available for the unit. When unlocking the lockout setting, indicate ‘Lockout Setting’ of [01] Lookout set-
ting in each setting mode and set ‘Unlock’. To enable lockout setting again, set ‘Lock’. Even when lockout setting is enabled,
it is available to confirm the each setting value. ‘DATA (Locked)’ is indicated in that case.