F2AP
EM-5436 Rev.4
P. 1 / 2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
DC/FREQUENCY CONVERTER
MODEL
F2AP
INSTRUCTION MANUAL
BEFORE USE ....
Thank you for choosing M-System. Before use, please check
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System’s Sales Office or representatives.
■
PACKAGE INCLUDES:
Signal conditioner ...............................................................(1)
■
MODEL NO.
Confirm Model No. marking on the product to be exactly
what you ordered.
■
INSTRUCTION MANUAL
This manual describes necessary points of caution when
you use this product, including installation, connection and
basic maintenance procedures.
POINTS OF CAUTION
■
CONFORMITY WITH EU DIRECTIVES
The actual installation environments such as panel configu-
rations, connected devices and connected wires may affect
the protection level of this unit when it is integrated in a
panel system. The user may have to review the CE require-
ments in regard to the whole system and employ additional
protective measures to ensure CE conformity.
■
POWER INPUT RATING & OPERATIONAL RANGE
Locate the power input rating marked on the product and
confirm its operational range as indicated below:
24V DC rating: 24V ±10%, approx. 80mA
■
GENERAL PRECAUTIONS
Before you remove the unit or mount it, turn off the power
supply and input signal for safety.
■
ENVIRONMENT
• Indoor use
• When heavy dust or metal particles are present in the
air, install the unit inside proper housing with sufficient
ventilation.
• Do not install the unit where it is subjected to continuous
vibration. Do not subject the unit to physical impact.
• Environmental temperature must be within -5 to +55°C
(23 to 131°F) with relative humidity within 30 to 90% RH
in order to ensure adequate life span and operation.
• Be sure that the ventilation slits are not covered with ca-
bles, etc.
■
WIRING
• Do not install cables close to noise sources (relay drive
cable, high frequency line, etc.).
• Do not bind these cables together with those in which
noises are present. Do not install them in the same duct.
■
AND ....
The unit is designed to function as soon as power is sup-
plied, however, a warm up for 30 minutes is required for sat-
isfying complete performance described in the data sheet.
COMPONENT IDENTIFICATION
Body
Zero Adj.
Span Adj.
Connection
Diagram
Specifications
Euro Type
Terminal Block
INSTALLATION
Set the unit so that its DIN rail adaptor is at the bottom.
Position the upper hook at the rear side of the unit on the
DIN rail and push in the lower.
When removing the unit, push down the DIN rail adaptor
utilizing a minus screwdriver and pull.
DIN Rail
35 mm wide
Spring Loaded
DIN Rail Adaptor
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the con-
nection diagram on the side of the unit.
+
–
+
–
OUTPUT
5
6
POWER
7
8
+
–
INPUT
1
2
• Open Collector
Output Connection
Examples
+
–
5
6
+
–
• Voltage Pulse
+
–
5
6
+
–
SCREWDRIVER (–)
PIN TERMINAL
MULTI-STRAND CABLE
1.25 mm
2
(.02 in
2
)
PHOENIX CONTACT
AI 1,5-8BK recommended
SOLID CABLE
1.4 mm (.06) dia.
8 mm (.32)
STRIPPED LENGTH
•
Wiring Procedure for Euro Type Terminal Block
