M/A-Com M7100IP, Installation Manual

Page: 26 / 60

26
7 CONTROL UNIT MOUNTING
Mount the control unit within convenient reach of the operator, and where it
will not interfere with the safe operation of the motorcycle. Figure 7-1 shows
a typical installation of the control unit and microphone. Note also, the
location of the option switch for the Headset Option.
Due to the large number of different makes and models of motorcycles, it is
up to the installer to decide how to mount the control unit and optional
equipment. Mounting brackets for all makes and models are not available
from the factory, making it necessary to obtain a custom made bracket.
When designing and mounting the control unit bracket, the following
guidelines should be considered.
•
The installation must NOT interfere with steering or operation of the
motorcycle.
•
Mounting locations must NOT interfere with the driver or with
instrument visibility.
•
The installation should provide easy access to the radio operating
controls.
•
Rounded corners/edges should be employed to the maximum extent
possible.
CAUTION
Be careful to avoid damaging some vital part of the
motorcycle if it becomes necessary to drill mounting holes.
Also, always check to see how far the mounting screws will
extend below the mounting surface before installing.
Caution must be exercised to not drill through the gasoline
tank.