Page 41 of 51
(North America Edition)
©2019 Lytx, Inc. - Confidential & Proprietary.
For Standard size:
Materials
Provided:
l
Remote Push Button - Standard
NOT provided: Hole saw or stepped cone cutter
Mount the Remote Push Button
1. Find a suitable mounting location for the
button:
a. Standard size: The location must be within a fixed panel with space for a 0.75-
inch hole. There must be 2.75 inches of clearance behind the panel.
b. The location should allow the driver to easily push the button while seated in the
driver's seat.
c. The button should not be placed where the driver may accidentally push the
button.
2. Using a hole saw/stepped cone cutter, drill a hole into the panel.
3. Bring the Remote Push Button assembly through the hole and connect it to the Vehicle
Interface Cable/Non-ECM, Device Power Only Cable. Refer to the
.
4. Mount the button into the hole. Secure it from the inside with the hex nut.
Assign the Input in the Lytx Installation Tool
To complete installation of the Remote Push Button,
its input must be properly assigned in the Lytx Install-
ation Tool.
To assign the input:
1. Go to the Assign Device Inputs screen in the
Lytx Installation Tool.
2. Assign GIO C (Blue) to
Remote Record Button.
3. Test the installation. Press either blue button
on the device to manually record an event. The
LED status lights on the SF-Series device will
light up green one-by-one from the left to right
until all are lit, indicating the test was
successful
Note: After assigning the Remote Push Button, the Lytx Installation Tool may take up to
several minutes to detect the assignment. Please wait for detection before troubleshooting.
