C MX 5710 Reference Manual. Rev 1.0
Page 19 of 36
Reference Source Selection
The reference of the C MX 5710 for the
frame sync functionality can either be
connected to the rear connection panel
or the reference input of the rack
frame.
To determine from where the module
receives the reference signal, simply
drag and drop the line either to the “Ref Board” or “Ref Rack” input node of the
flexGUI (Figure 11:
Video Processing
Each SDI output has its own Video Processor. The following description applies
to all of the SDI outputs equally (unless otherwise noted).
Aperture Correction
Horizontal aperture correction is provided for each output channel, which can be
used to sharpen or soften the video signal. (This is sometimes required for down
converted video signals as the filtering process rolls off the high frequency very
slightly). If adjusted in the positive direction this will increase sharpness, if
adjusted in the negative direction this will soften the image.
There is a check box to switch aperture correction ON and OFF. Setting the
Aperture C
orrection to “OFF” has the same effect as setting in the numerical
value to zero.
Figure 12: Video Output Processing
Figure 11: Selecting Analog REF Source
