Reference Manual S VD 3062 Version1.4
Page 18
Dip Switch 2
When set to
ON
this configures output 1 as reclocked, if
set to
OFF
output 1 is non-reclocked
Dip Switch 3
When set to
ON
this configures output 2 as reclocked, if
set to
OFF
output 2 is non-reclocked
Dip Switch 4
This switch configures enables emergency switching.
ON
activates the emergency switch. If the selected
input is lost, the modules will switch automatically to the
next active input.
OFF
disables emergency switching.
Dip Switch 5-8
Used for address configuration for optional remote
control panel on parallel or RS485 interface:
ADR 0:
Direct Connect for Panel Version 1 and 2
ADR 1 .
.
ADR 6:
Address of S VD 3062 for connection to
Panel Version 3 or via RS 485
Factory Preset Condition
The S VD 3062 is delivered preset for the following
mode of operation:
Local control
enabled
Outputs 1
non-reclocked
Outputs 2
non-reclocked
Emergency switch
disabled
If this is the mode of operation required, then no
adjustments are necessary.
Summary of Contents for MiniModule S VD 3062
Page 9: ...Reference Manual S VD 3062 Version1 4 Page 9 Figure 2 Module Layout...
Page 22: ...Reference Manual S VD 3062 Version1 4 Page 22 Panel Version 3 R CP 3062 D Sub 25 polig male...
Page 31: ...Reference Manual S VD 3062 Version1 4 Page 31 This Page is intentionally left blank...
Page 32: ...Reference Manual S VD 3062 Version1 4 Page 32 Notes...
