Reference Manual S VD 3062 Version1.4
Page 17
Switch Settings
Below the switch settings for the 8-position dip-switch
are defined.
Switch Function Detail
Dip Switch 1
This switch is used to enable or disable local
adjustments. Set to
ON
enables the setting of the other
dip switches to configure the module. Set to
OFF
will
prevent any switch settings taking effect.
If any setting is executed via the optional LYNX control
system, the local control will be disabled. In this case
DIP Switch one has to be toggled ON-OFF-ON to
reaquire local control. LED 3 will be on (GREEN) if local
control is enabled.
Note.
The module has a microcontroller and flash ram. When this
switch 1 is set to
ON
any configuration settings made on the module
with the dip switches will automatically be written into flash ram and
stored. (see Auto Store) The module will function normally with the
switch left in the
ON
position but it is recommended to set it to
OFF
to
prevent accidental changes to the stored module configuration if
the switches are moved.
Switch
Setting
Function
ON
Local adjustment enabled
1
OFF
Local adjustment disabled
ON
Output 1 reclocked
2
OFF
Output 1 non-reclocked
ON
Output 2 reclocked
3
OFF
Output 2 non-reclocked
ON Emergency
switch
active
4
OFF
Emergency switch disabled
5
Adr (0)
Settimg for Remote Control Panel
6
Adr(1)
Settimg for Remote Control Panel
7
Adr(2)
Settimg for Remote Control Panel
8
Adr (3)
Settimg for Remote Control Panel
Summary of Contents for MiniModule S VD 3062
Page 9: ...Reference Manual S VD 3062 Version1 4 Page 9 Figure 2 Module Layout...
Page 22: ...Reference Manual S VD 3062 Version1 4 Page 22 Panel Version 3 R CP 3062 D Sub 25 polig male...
Page 31: ...Reference Manual S VD 3062 Version1 4 Page 31 This Page is intentionally left blank...
Page 32: ...Reference Manual S VD 3062 Version1 4 Page 32 Notes...
