Lynx Adventure 800, Operator'S Manual

Page: 47 / 75

46
ENGLISH
Fuel flooded engine
Install new spark plugs and restart engine.
Rear suspension slider shoe sliding
Slider shoes are cooled and lubricated by snow. When riding at moderate or high speed on a
thin-snow-covered surface, slider shoes may stick on metallic track guides.
Run snowmobile on a surface covered by snow or drive snowmobile at very low speed.
Have slider shoes inspected by an authorized Lynx dealer.
NOTE! This situation comes up the more high profile track is. Avoid driving on hard
packed snow, ice surface or other surface, that has not enough snow to ensure the
lubrication.
It is noticeable that tracks with 35 mm or more high profile are not meant for the trail ride
(hard surface) but only for the deep snow ride. If the vehicle which is equipped with this kind
of track, is driven on hard packed snow, slider shoes may stick on track metallic parts or the
track can get damaged.
FLUID LEVELS
It is recommended that the assistance of an authorized Lynx dealer be periodically
obtained on other components/systems not covered in this guide. Unless otherwise
specified, engine must be cold and not running. The tether cord cap must be removed
for all maintenance procedures.
CAUTION: Vehicle must be on a level surface before checking any fluid levels.
Brake system
Check brake fluid in reservoir for proper level. Add fluid as required.
CAUTION: Use only DOT 4 brake fluid from a sealed container.
Brake fluid reservoir
1.Minimum
WARNING!