WARNING
TO PREVENT POSSIBLE INJURY, INSTALL WALL STATION OUT OF THE REACH OF CHILDREN AND IN
A LOCATION WHERE THE DOOR CAN BE SEEN WHEN THE OPENER IS ACTIVATED. DO NOT MOUNT
WALL STATION NEAR OR NEXT TO GARAGE DOOR.
Tools Required – Power Drill, Phillips Head Screwdriver, Small Flat Blade Screwdriver, 3/32 inch drill bit,
hammer, wire cutter/stripper.
Wired Wall Station:
Uncoil and connect supplied bell wire to wall station terminal screws as illustrated (see next page).
Locate wall station adjacent to service entrance door
at a minimum height of 5 feet and at least 6 feet away
from garage door.
Wall Station
5 Foot
Minimum
8
Wired Wall Station Installation
IMPORTANT:
CONNECT WIRES TO WALL STATION TERMINALS USING A “J” HOOK CONFIGURATION.
IF WIRE IS COMPLETELY WRAPPED AROUND TERMINAL SCREW IT CAN PREVENT PROPER CONTACT.
Fasten the wall station with supplied flat head screws.
Pilot drill mounting holes using 3/32 inch drill bit and
install screws tightening them just enough to seat
wall station against wall. Do not over tighten. Be sure
wires are passed through notch at top of wall station
and are not trapped between wall and wall station.
IMPORTANT: THE STANDARD WALL STATION OR DELUXE WALL STATION MUST BE THE ONLY TYPE USED
FOR PROPER DOOR OPERATION. THE USE OF ANOTHER WALLSTATION NOT SUPPLIED BY LYNX COULD
CAUSE OPENER TO MALFUNCTION.
13
