NANO Version 2.16
February 2017
Page 11 of 27
(SD card error) Nano is powered on with rocker button
PWR
GPS LOG
BT
Err
Description
After pressing rocker button
One second later SD card error (for 5 seconds)
Startup sequence 1 OK
Startup sequence 1 OK
Power led blinks
After short pressing of rocker button up or down battery
level is indicated
After long pressing of rocker button, nano will turn off. Red
and green LED will blink isophasic.
Digital signature failed
PWR
GPS LOG
BT
Err
Description
Digital signature failed
3.5
NanoPower cable
The NanoPower is a special device, which converts 12V to 5V power supply for NANO and
PDA. It also translates levels of serial signal to match NANO signal level and PDA or
computer signal level.
Connect the red and black wire to 12V power supply.
Maximum input voltage is 24 Volts.
The NanoPower has two plugs. On one side there is a standard USB-A connector. Use
included USB-A to mini-USB cable and plug NANO to this side. Any standard USB-A to mini-
USB cable is suitable. On the other side there is a RJ45 plug. This plug is designed for a PDA
or a computer.
RJ45 plug is NOT designed in accordance with IGC standard. It can be used only
with dedicated cable. Do not plug unknown cable to it as it may damage
NanoPower circuit.
Pin description on the NanoPower RJ45 is given on a picture below.
Summary of Contents for NANO
Page 2: ......
