NANO Version 2.16
February 2017
Page 21 of 27
5.2.4
Automatically turn off Nano, when flight is finished
This option is very useful for Nano being installed more or less permanently into the glider. If
this option is enabled, Nano will automatically switch off 30 minutes after flight is finished.
This option will work only if start recording at power on is disabled.
This option can be used only when nano is all the time connected to external
power supply. It turns on when external power supply is present and turns off
after 30 minutes, if no external supply is present and flight is finished.
5.2.5
Bluetooth
Check the Enable Bluetooth checkbox if you want to turn it on. By default Bluetooth is
disabled.
When Bluetooth is enabled, the NANO will consume more power and the total
endurance of a new and charged battery will reduce to approximately 14hours.
When Bluetooth is enabled, there will be no output on the wired serial interface
and task declarations can only be uploaded via Bluetooth.
5.2.6
NMEA output
Check Enable NMEA output to output NMEA data. The NANO will transmit the following
NMEA sentences GPGGA; GPRMC, LXWP0 every second and LXWP1 once per minute.
NMEA can be output to either the serial interface or Bluetooth but not to both
simultaneously.
Change the NMEA baud rate, if you want to output NMEA at different baud rates.
Summary of Contents for NANO
Page 2: ......
