LX 7007
pro IGC V1.0
Apr.2005
Page 35
GSPEED DIF.
is the simplest method. The calculation is based on measuring ground speed changes while
circling
. A
minimum of two full circles are necessary to obtain an accurate wind. The message
WAIT2 or WAIT
1
informs the
pilot how many circles are left to get the result. It is very important
to keep the speed constant
while circling to ensure
that accurate results are obtained. The pilot is able to adjust the wind using manual corrections through the Offset
Input.
POS. DRIFT
is the most accurate method. It is based on measuring the drift due to the wind during 6 full circles.
These circles have to be flown accurately and at a constant speed to achieve the best results.
WAIT 6
to 1
indicates
how many circles are left until a result is produced.
COMBINATION
is using a combination of two methods:
-during the climbing a very realiable method GSPPED DIF. is used and during straight flight an algorithm which
calculates wind after input of GS,GTand TAS. The change over between methods is done automatically.
COMPONENT
calculates the
wind component
(head or tail wind). The calculation is based on measuring the
difference between GS and TAS during straight flight.
FIXED VALUE
is not a calculation; it simply allows the pilot to input the wind vector that he wants to use.
COMPASS
wind calculation method is available only with the optional compass device. Its use is described in the
COMPASS manual.
2.2.4
TP - Turn Points
The LX 7007 PRO IGC has the memory capacity to store up to 600 turn points. The turn point name can have a
maximum of 8 characters (letters or numbers, no lower case letters and no special signs except * and _ ). The menu
structure is the same as in the APT menu - either four or five pages depending on the set up parameters. A turn point
can be added to the database in one of four ways:
•
Manual input
•
Copy from APT database
•
Data transfer from a PC, LX20 or Colibri (*.DA4 format)
•
Input of actual present position
The procedure is similar to the method of selecting an
APT
. While in any
TP
page, press
ENTER
and a menu showing
SELECT, EDIT, NEW, DELETE, TEAM
and
WIND
will be presented.
2.2.4.1
TP SELECT
To select a turn point simply replace the stars with the first letters of the TP.
IMPORTANT!
The LX 7007 PRO IGC is able to sort the turn points alphabetically or by distance from present position. The method
used is defined in the setup menu. The default setting is alphabetic. If sorting by distance is selected, then the
nearest
TP
will appear after selection (
all stars confirmed with ESC
). To search for the TP use
UP/DOWN
selector and
confirm with ENTER.
It is also possible to select TP by
using ZOOM
selector. This works exclusively from
the first page.
To change the TP
simply rotate the
ZOOM
selector.
Method
Offset input
