22
Insert / Remove a Spare Battery
MX7 Cradle Reference Guide
E-EQ-MX7DKRG-C
Insert / Remove a Spare Battery
Pre-requisites
: The steps outlined in
Assemble/Attach the AC Power Adapter
have been
completed and the cradle has a dependable power source. The cradle has been
bolted to a stable surface, if required.
Note:
Do not drop or slam the spare battery into the charging bay. Damage may result.
A fully depleted spare battery recharges in approximately four hours in the MX7 powered cradle.
The spare battery well is molded in the shape of the MX7 main battery. The spare battery can be
inserted in the battery well in only one direction.
When there is an MX7, with or without a handle, docked in the cradle, a spare battery can still be
inserted in the charging bay. You do not need to undock the MX7.
Figure 15 Spare Battery Charging Bay
Insert --
Tilt the end (without the latch) of the spare battery pack into the upper end of the battery
charging well, and firmly press the other end (with the latch) until the battery is fully inserted into
the battery well.
Push down on the battery pack until it clicks into place. This will ensure the charging contacts on
the spare battery connect with the charging contacts in the battery well. The Spare charging bay
LED illuminates.
Remove --
Remove the charged battery by pressing the latch in and pulling the battery up with a
hinging motion and out of the charging bay. The Spare charging bay LED turns Off.
A green spare battery LED signifies the spare battery is fully charged.
