40
Manuel_VS450Z18/VS450WZ18_V02_En
3.4.4
TILT OVER ANGLE (
MENU
=> SETUP => TILT OVER ANGLE)
This option is used to set the limit of the horizontal view angle so that the trim ring
or ceiling does not obstruct the horizontal image when zooming out (wide
angle).
ON
: In some installations it is desirable for the dome camera to be able to see
above the horizon. When this option is chosen, the dome will tilt up over the
horizon (About 10 degrees). When the lens is zoomed out, you can see the
ceiling line. But when the lens is zoomed in, the viewing angle is narrower, and
the ceiling line disappears.
Without Bubble
: The tilt range of the camera is limited to see the horizon so the
picture shows part of the ceiling line.
With Bubble
: The tilt range of the camera is limited to see below the horizon (- 10
degrees).
3.4.5 CALIBRATION
(
MENU
=> SETUP => CALIBRATION)
RESET ORIGIN: Calibrate the ORIGIN point.
OFFSET ORIGIN: Adjust the small amount of position error from re-installation.
VIEW ANGLE SETUP
TILT OVER ANGLE: W/O BUBBLE
SAVE AND EXIT
CALIBRATION
RESET ORIGIN
OFFSET ORIGIN
OFFSET: ENABLE
AUTO CALIBRATION:
OFF
SAVE AND EXIT
