20
For your safety, read the following before lighting:
1.
STOP!
Read the safety information above on
this label.
2.
Set the thermostat to lowest setting or switch
to off
3.
Turn off all electrical power to the appliance.
4.
This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
5.
Remove control access cover
6.
Identify that the module control switches are
set to the desired operation. Check if the
electronic module is powered by back up
batteries and/or AC adapter. The backup
batteries will light the appliance even if the
AC power has been turned off.
7.
Wait five minutes to clear out any gas. Then
smell for gas, including near the floor. If you
smell gas, STOP! Follow “B” in the safety
information on this label. If you don’t smell gas
go on to the next step.
8.
Turn up thermostat or turn on power switch –
sufficient time must be allowed for air to escape
from lines if the unit is being lit for the first
time.
9.
Replace control access cover.
10.
Turn on all electric power to the appliance.
11.
Set thermostat to desired setting.
12.
If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance”
and call your service technician or gas supplier.
Lighting Instructions
Operating Instructions
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage
and personal injury or death
A. This appliance is equipped with an ignition device which
Automatically lights the pilot. Do Not try to light the pilot
by hand.
B. BEFORE LIGHTING smell all around the appliance area
For gas. Be sure to small next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMAELL GAS – Do not try to
Light the appliance – Do not touch any electric switch; do
not. Use any phone in your building – Immediately call your
gas supplier from a neighbour’s phone. Follow the gas
supplier’s instructions. – If you cannot reach your gas supplier,
call the fire department
C.
Use only your hand to push in or turn control knob.
Never use tools. If the knob will not push in or turn
by hand don’t try to repair it, call a qualified service
technician. Force or attempt repair may result in a
fire or explosion.
D.
Do not use this appliance if any part has been under
Water. Immediately call a qualified service
technician. To inspect the appliance and replace any
part which has been under water.
