![background image](http://html1.mh-extra.com/html/luxor/mbo-36/mbo-36_installation-and-owners-manual_1952569007.webp)
The MBO-36 is shipped with non-combustible panels which must be installed with the appliance
to conform with to certified safety standards. the panel is secured above the Cleanface
Finishing and Facing Material Considerations
In order to adequately drain the
appliance a sliding drain tray is built
into the lower section of the unit. In an
application where the existing stainless
face will be featured, the tray can
remain in the inner most position. If a
non-combustible material like stone or
brick is to be added over the facing the
drain tray
must not
be covered. Doing
so will prevent proper water drainage.
The tray can be pulled out to match the
thickness of any desired material.
Sliding drain tray
Mantel Requirements
Top edge of
fireplace opening
Framing
The attached chart represents the maximum allowable
mantel or shelf limits using combustible materials determined
by in the certification guidelines. Due to the wide range of
designs and materials of non-combustible mantels, shelves,
and overlays caution must be exercised when choosing to
finish this appliance. Any such installations must conform to
local codes. For any further information contact CFH Mfg.
Mantel/Surround Side clearance
1.5”
framing
No combustible materials
can extend past this line
Fireplace Cleanface
Side wall
7