![background image](http://html1.mh-extra.com/html/luxor/lbv-3/lbv-3_installation-and-owners-manual_1952566007.webp)
Direct Vent Venting
IMPORTANT:
This appliances venting system is room sealed, which
means that there should be no provision to allow room air to be used in the
combustion process.
Note:
Only UL Listed 3” Aluminum venting may be used with the model
Luxor.
PLANNING YOUR VENT INSTALLATION
This type of direct vent system may only terminate in the
following way: Vertical termination using a D uravent 3” adapter
and cap (see Vent parts list). There are limitations to the vertical
length to a maximum of 30 feet from the fireplace base, and a
minimum of 8’ from the fireplace top.
When calculating the length of the vent pipe from the outlet of the
appliance to termination, allow for any offsets in the chase and
Apply RTV sealant to the appliance vent pipe and slide over air intake
and exhaust pipes.
Secure using the eight self tapping screws (four per flex)
Slide unit into the opening, taking care not to damage the liner (allow
enough slack for final surround assembly).
WARNING: Failure to position the parts in accordance with these
diagrams or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
Never vent appliance into room or building vent only to outdoors. The
vent terminal shall not be recessed into a wall or siding.
At the top of the chimney slide the connector
plate over the two flex liners.
Attach the termination cap to the flex pipes
using the eight screws provided
Finally seal the connector plate to the
chimney (fire cement).
Note: Inspect vent connection prior to installing trim surrounds.
Typical components used in above install
991 DV GS cap (high wind)
980 DV GS cap (low profile)
930 DV GS extended cap
2150 DV GS flex
923F DV GS appliance flex connector
923GK DV GS Chimney liner kit
Page 5
MAINTENANCE: In the event service is required which alters vent system, proper reassembly & resealing of the vent-air
intake system.