4
ENGLISH
Installation
Ventilation
Place the inverter in an open space to make sure that the outflow of
emitted heat can run freely. Aim for at least 50 cm free space on all
sides.
Connection
Make sure that the inverter is turned off before connecting it to the 12 V battery. Use the included red and
black cables. Connect the red cable to the positive DC input (7) and the positive pole of the battery. Connect
the black cable to the negative DC input (8) and the negative pole. Make sure the DC connections are tight.
When connecting the inverter for the first time, it is recommended to connect the grounding cable. Connect
the grounding cable to the grounding plug (10) of the inverter and attach the tong to a ground source.
Double-check the connection before turning on the inverter. If the cables are connected tightly and correctly,
press the On/off switch (5). The power indicator turns green and the display turns on. Note! Never reverse
connect the cables. If the inverter alarms in any way, turn it off.
Before connecting the load, calculate the total power consumption of the output load and make sure that it
does not exceed the rated power. Make sure the equipment you are about to connect is turned off. Connect
the load to the inverter and turn it on one by one. Start with the largest load. After it has start up properly,
go on with the next one. Remember to only connect one electrical equipment to a socket.
When you are about to disconnect your equipment and inverter, start with turning off the load and then turn
off the inverter. When all is turned off it is safe to disconnect.
Remote control
Use the remote control to turn the inverter on or off. Connect the RJ12 cable to the remote port (6) and
the remote control. Make sure the On/off switch (5) of the inverter is off. The remote control has a fault
indicator that shows the status of the inverter:
Status
LED light
Red
Green
Input under voltage alarm
OFF
ON
Input under voltage
shut down
ON
ON
Input over voltage shut down
ON
ON
Over load shut down
ON
ON
Over temperature shut down
ON
ON
Output short circuit
ON
ON
