43
While the unit is used, an unusual phenomenon may be confused as a malfunction for a certain reason. Prior to asking us for our official
sole distributor of your country, please check the table below and read the instruction manual. If the cause of the malfunction cannot
be identified, please contact your dealer. When we have once accepted your request for repair services, inspection fees and traveling
expenses may be claimed even though the unit is found to be normal.
Before Asking for Repair
Problem
Cause/Solution
Ref. page
No power is supplied even
though the main power switch
is pressed.
The standby indicator does not
light.
· Connect the power cable to the AC inlet and the AC outlet firmly.
21
The disc tray comes out even
after the tray is closed.
· Set the disc on the disc tray correctly.
23
· Clean the disc to remove dirt.
2
Playback cannot be performed.
· Clean the disc to remove dirt.
2
· Set the disc on the disc tray correctly.
23
· Remove dew condensation from the interior of this unit.
1
· Put the disc on the tray with the label facing upwards.
(label face upward)
No sound is generated. / Sound
volume is too low. (Digital input)
· Connect digital cables correctly.
20 - 21
· If the USB is selected as an input source, select this unit (D-06u) as
the output destination by configuring the sound setting of a PC/Mac.
Refer to the in-
struction manual of
the PC/Mac or the
software in use.
· If the unit (D-06u) cannot be selected even when trying the solution
above, reconnect the USB cable.
· If the USB is selected as an input source, adjust the sound volume by
configuring the sound setting of a PC/Mac.
· If the USB is selected as an input source, adjust the sound volume on
a player software of a PC/Mac.
· Ensure that the sampling frequency and the number of quantization
bits of the reproduced digital signal are applicable to this unit.
18 - 19
· Check to see whether "UNLOCK" of the digital input is displayed or
not. (When the digital signal from the digital device is not synchro-
nized with this unit, the source may not be reproduced.)
The remote control cannot be
operated.
· Operate the remote control within the specified operating range.
9
· Replace the remote control battery with a new one.
8
· The remote control infrared receiver is exposed to direct sunlight or
strong light sources (such as inverter fluorescent lights). Change the
installation place or angle to avoid the exposure to light sources.
9
An electronic device such as a
television malfunctions.
· Some devices equipped with a wireless remote control receiver may
malfunction when the remote control of this unit is operated. Keep
this unit away from such devices.
9