LX120
V. 05 – 23/07/2014
4
©Velleman nv
Refer to the ArKaos MediaMaster software manual for detailed instructions on programming this product
(www.arkaospro.com).
Art-Net
Art-Net is a communication system that allows DMX512 to be sent over Ethernet.
The Art-Net protocol was developed by the company Artistic Licence Engineering and has now been
published into the public domain.
The protocol description is available on the following link:
www.artisticlicence.com/WebSiteMaster/User%20Guides/art-net.pdf
Various commercial and open source programs support the Art-Net protocol.
7.
Mounting
Refer to the illustration in the section Overview above.
Mounting the device
The device can be mounted in almost any orientation.
Mount the device in the desired angle using the included bracket.
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
The installation must always be secured with a secondary attachment e.g. a safety cable.
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
Make sure there is no flammable material within a 0.5 m radius of the device.
Vertical mounting with optional LX121 bracket
You can hang up to 16 panels vertically using the optional bracket (order
code LX121).
Attach the other panels with the locks at the top and bottom of each
panel.
Vertical mounting without LX121 bracket
If you do not use the LX121 bracket, you can attach up to 4 panels
vertically in a single column using the appropriate clamps.
Position the bracket [1] upwards and attach it using the appropriate
clamps.
Horizontal alignment
The device has brackets for horizontal alignment.
These brackets are for alignment purposes only and cannot be used to support the device.
Additional hardware is required for horizontal mounting.
