25 |
P a g e
STEP 3
Fasten probes onto the keder.
•
Start on Idle side.
•
Remove the screws from the probe.
•
Fold the keder out of the way.
•
Insert the probe into the bottom rail.
•
Release the keder and slide the probe out of the bottom rail while guiding the
keder flaps into the slot.
•
Ensure the flap of the keder is fully inside the slot on the probe before securing
(fig B1).
•
Fasten the probe screws into the keder flaps (fig B2).
•
Slide the bottom rail over the probe and screws 12-22 mm so the probe can be
installed on the other side, then repeat the process (fig B3).
Note the brush will also slide in the bottom rail.
•
Slide bottom rail back to the middle position once both probes are located
inside the bottom rail and secured to the keder.
STEP 4
Installation of the screen guides.
A. Position the bottom rail.
Summary of Contents for EVO MagnaTrack
Page 1: ...EVO MagnaTrack Installation Manual ...
Page 12: ...12 P a g e FACE FIT APPLICATION ...
Page 19: ...19 P a g e REVEAL FIT INSTALLATION ...
Page 22: ...22 P a g e STEP 2 Install Evo MagnaTrack Channels STEP 3 Repeat steps 1 and 2 for other side ...