R
Please Read
Advanced Programming
Delete a Zone
20
Modify Reply Back Settings
21
Modify Acknowledgment Settings
22
Operation
Set Up Scenes (accessed from Tabletop/Wall
Control, single zone)
23
Set Up Scenes (not accessed from Tabletop/
Wall Control, multiple zone)
24
Troubleshooting Guide
25
ASCII to Hexadecimal Conversion
26
Warranty
27
Contacts
28
Contents
Installation
System Overview
2
Mounting
4
Programming
Determine Zone Types and Number
5
Configure Zone Types
6
Add a Zone
7
Set Data Flow Control Method
8
Protocol
General Notes
9
Command Summary
12
Device Control Commands
14
Configuration Commands
17
Monitoring Control
19
Setup and Installation Guide
RTA-RS232
RadioTouch
TM
RS232 Interface
This manual is an addendum to the
RadioTouch
Installer’s Guide. The procedures to set up a
RadioTouch
RS232 interface are contained in this manual. The
RadioTouch
RS232 interface is simply another transmitter in the
RadioTouch
System. The RS232 interface has the ability to communicate with up to 10 unique zones of lights, Sivoia® QED shades, or
contact closure outputs in a single room. This device can not report the status of the lighting zones,
Sivoia
QED shades, or
contact closure outputs back to the host RS232 device.
Danger!
This
RadioTouch
system must not be used to control equipment, other than lighting, which is not visible from
every transmitter location. It also must not be used to control equipment which could create hazardous situations
such as entrapment if operated accidentally. Examples of equipment which must not be controlled by this
RadioTouch
system include (but are not limited to) motorized gates, garage doors, industrial doors, microwave ovens, heating
pads, etc. It is the installer's responsibility to ensure that the equipment, other than lighting, being controlled is visible
from every transmitter location and that only suitable equipment is connected to this
RadioTouch
system.
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by Lutron Electronics Co., Inc. could void the user's authority to
operate this equipment.
R
adioTouch
TM
Coopersburg, PA 18036 USA
RTA-RX-F-SC
LISTED 243C
I
nd. Cont. E q.
1 2
3
4
5
6 7
8
9 10 11 12 13 14 15 16
O
cc
.
C
o
m
O
cc
S
ig
24
V
C
ir
C
o
m
CC
O
1
CC
O
2
CC
O
3
CC
O
4
CC
O
5
CC
O
C
o
m
+
_
PELV (
C
lass
2
:
U
S
A
)
PWR
STAT
PROG
100 H
r/100%
®
PS S
ig
P/N 500-10634
©
2006 Lutron Electronics Co., Inc.
1
2
3
4
5
ON
USA, Canada
1-800-523-9466
Mexico
1-888-235-2910
®
www.lutron.com
15
V
CONFIGURACIONES
REGLAGES
SETTINGS
Refer to the Installers Guide for more
detailed instructions.
Consulte la Guía de Instaladores para
información más detallada.
Référer au Guide d’installation pour plus de
renseignements détaillés.
120/277 V 60 Hz
16 A Max.
0-10
V
