R
RadioTouch
TM
RTA-RS232 Programming and Operation Guide 13
Command Set (continued)
Command Summary
RTA-RS232 Commands
Command
Description
Page
PS
Sets the indicated zone to a predetermined preset level
14
XC
Sets the intended zone to an explicit level between the minimum and maximum levels
15
BSTP
Tells the RTA-RS232 to raise or lower the level for the indicated zone
15
ESTP
Tells the RTA-RS232 to stop raising or lowering the zone level
15
PSA
Tells the indicated zone to enter/exit Preset Adjust mode
15
SPS
Programs the indicated preset level to the current light level
16
PHC
Tells the indicated zone to enter/exit daylight sensor calibration mode
16
PING
Forces a prompt from the RTA-RS232 (used on power-up to start data flow)
16
Configuration Commands
Command
Description
Page
ENTER
Tells the RTA-RS232 to enter Configuration mode
17
EXIT
Tells the RTA-RS232 to exit Configuration mode
17
TYPE
Sets the zone type to Lights, Contact Closures, or Unassigned
17
RB
Tells the RTA-RS232 to turn Reply Back mode on or off
17
ACK
Turns Acknowledgment mode on or off
17
ADD
Adds the RTA-RS232 to an RF controller
18
DELETE
Deletes the RTA-RS232 from an RF controller
18
RPT
Allows the host to query the configuration settings of the RTA-RS232
18
RTA-RS232 Responses
Command
Description
Page
! (PROMPT)
Tells the Host there is room in the RTA-RS232 buffer for another command
19
CON
Informs the host of the current configuration settings
19
ERROR
Provides error codes when an error is detected (Reply Back mode must be on)
19
OK
Responds OK when a command is successfully processed (Reply Back mode must be on) 19
ACK
Issued by the RTA-RS232 when it complete RF transmission of the current command
19
(if Acknowledgment mode is turned on)
