10.
To
exit the installation mode
, press the disarm button
two times. The
keypad emits a signal sound and the power LED is switched off.
Now you can arm and disarm the alarm panel by means of the keypad.
Changing the PIN code to switch between the different modes of the alarm
panel:
You can change the PIN code in the web interface of the alarm panel. Open the
menu “Home”
“Pin codes” and change the existing PIN code or enter a new one.
Controlling the alarm panel by means of the keypad:
1.
Arm the alarm panel:
PIN code (default 1234) + arm button (a long signal is emitted + the
status LED lights up).
2.
Disarm the alarm panel:
PIN code (default 1234) + disarm button
(two signals are e the
status LED lights up blue).
3.
Switch to home mode:
PIN code (default 1234) + home button
and press 1, 2, or 3 to select
the corresponding home mode (three signals are e the status LED
flashes red). If you do not press any number key after pressing the home
button, the alarm panel will switch to home mode 1.
Dual-key functions:
The keypad features pre-defined dual key commands that allow you to trigger a fire,
panic, or medical alarm
without entering a PIN code
. To activate the dual key
functions, please proceed as follows:
Enter the
installation mode
of the keypad (default 0000 + *). The power LED lights
up orange. To activate the dual key function, you need to enter the following
commands for the corresponding functions:
Activate panic alarm 1+3:
press * + 2
Activate fire alarm 4+6:
press * +3
Activate medical alarm 7+9:
press * + 4
Deactivate all dual key functions: press * + 5
Note (only XT2):
If you got to the menu “Sensors”
“List” and edit the keypad, you can define the
dual key commands (1+3, 4+6, 7+9). Thus, for instance, you can trigger individual
automations or directly switch to the home mode 2 or 3. A in detail description of the
different automation rules can be found in the chapter on Smarthome in the XT
manual.
Additional functions of the installation mode:
Adding the keypad to the alarm panel: press * + 7
Changing the installation PIN: press * + 6
Enter the current installation PIN (default 0000).
Press the status button
. A long signal is emitted.
Enter your new installation PIN code (4-digits).
Press the pound button (#). The new installation PIN code is now saved.
Summary of Contents for LUPUSEC XT
Page 1: ...XT Keypad Manual...
