Enable switching to arm / home mode without entering a PIN code: press * + 8
Disable switching to arm / home mode without entering a PIN code: press * + 9
To
exit the installation mode
, press the disarm button
two times.
Reset / factory default:
If you have forgotten your installation PIN code, you can restore the factory default of
the keypad in the following way:
1.
Open the keypad. Be aware that the tampering protection will be triggered!
2.
Remove the batteries.
3.
Press and hold the button “3” while you are inserting the batteries again.
4.
Release the button “3.”
After the reset, the installation PIN code will again be 0000.
Please note:
Attention
:
Change the standard PIN code (1234) as well as the
installation PIN code (0000) of the keypad to ensure that no one else
can control your alarm panel!
You can change the PIN code in the menu
“Home”
“PIN codes” of the alarm panel. To change the installation PIN
code, see above.
In the menu “Settings”
“Panel”
“Area Settings”
“Arming with failure”
you can allow that the alarm panel will always switch the mode irrespective
of errors.
If an error is displayed by a flashing error LED, it can be ignored by
entering the PIN code and the mode command again within ten seconds.
You can check (and deactivate / ignore) the current errors of the alarm
panel in the menu “Home”
Status”
“XT2 Status.”
The keypad only transmits status information when you enter a command.
Thus, it can transmit that the batteries are running low, but not that the
batteries are empty!
Additional notes (only XT2)
:
To activate different home modes with the keypad, at least firmware
version 0.0.2.7M is required. The keypad may not be older than September
2014.
Depending on the used PIN code, the keypad can control both areas
(requires at least firmware 0.0.2.7M).
In firmware version 0.0.2.13C, a “PIN code protection” was integrated. After
five incorrect PIN code inputs, the keypad is locked for 15 minutes. You
can enable or disable the “PIN code protection” in the menu “Settings”
“Panel”
“General Settings.”
LUPUS-Electronics
®
GmbH
Otto-Hahn-Str. 12, D-76829 Landau
Tel. +49 (0) 6341 93 55 3 0 Fax. +49 (0) 6341 93 55 3 20
E-Mail: [email protected]
www.Lupus-Electronics.de
Summary of Contents for LUPUSEC XT
Page 1: ...XT Keypad Manual...
