Lunar Caravans, User Manual

Page: 55 / 120

55
ELECTRICS
Fault Possible Cause Proposed Fix
No 230 volt Connecting lead between Check and connect lead as per 2.3C
output from PSU the site and Leisure
Vehicle not connected
RCD switched off Reset RCD as per 2.3D
RCD not operating Check supply polarity; if the RCD continues to fail contact your Dealer as there is probably an equipment or wiring fault
correctly
MCB switched off Reset MCB by switching OFF (down position) then back ON (up position), if the MCB continues to fail contact your Dealer as there is
propably an equipment or wiring fault
No or deficient supply Contact site Warden for assistance
from site
Other fault Contact your Dealer.
Control Panel Control panel has no Backlight/illumination may have switched off. Press the power button or select button to reactivate the backlight.
problems display Check batteries and fuses, turn PSU shutdown switch and charger switch on and ensure mains supply is connected.
Check control panel connecting lead at PSU and behind Control Panel. Contact your Dealer
12v Power turns off Battery protect feature has operated to protect the Vehicle battery and or the Leisure battery. See 3.6
Engine has been started, all equipment has been disconnected to meet EMC requirements. See 2.4
Control panel locked/ Observe control panel handling instructions.
erratic function Control panel software may have crashed. Reboot control panel by turning off the PSU isolate switch. Wait 30 seconds then turn the
switch back on.
No 12 volt output No 230V supply Check all above.
from PSU Charger not switched on Turn charger switch on, switch will illuminate
Battery not connected and Install charged battery as per 3.3.
/ or charged
Power button on control Turn power on at control panel
panel not switched on
Battery flat / Battery fuse Recharge battery, check fuses, check charging voltage is present at battery.
blown
Fuse blown
Check all fuses are intact and the correct value fuse is installed as per fuse table
Equipment switched off / Check equipment is switched on and connected to the 12V supply.
unplugged
3.8 Common Fault Table