Lunar Caravans ALARIA 2018, Handbook

Page: 37 / 146

37
ON THE ROAD
Start: Manual levelling
Before automatic levelling can be activated, you must set the zero point. For setting the zero point, you must FIRST perform the manual levelling
procedure.
REMARK: Do this by placing a spirit level in the centre of the caravan.
ATTENTION! Never put the rear brackets first to the ground. This in case creating too much load on the caravan.
Setting the zero point
Step 1 Press 1x on the button “ON/OFF” (no.5) to switch OFF the levelsystem after manual levelling.
Step 2 Press 1x on the button “ON/OFF” (no.5) to switch the levelsystem ON.
Step 3 Press 5x on the button “FRONT SIDE” (no.12)
Step 4 Press 5x on the button “REAR SIDE” (no.11)
All LED’s on the control panel light up. (the vehicle stands in zero mode)
Step 5 Press 3x on the button “RETRACT ALL JACKS” (no.8)
The zero point is programmed.
Step 6 Press 1x on the button “ON/OFF” (no.5) to switch the levelsystem OFF.
Remote control (optional)
Preface
The procedure described below has already been carried out at your dealer/installer.
Consider programming (setting) the remote control as a condition to make it possible to level the caravan automatically and/or manually. When this
operation, for some reason, has not been done or has been carried out incorrectly, it is not possible to level the caravan with the remote control.
Antenna
Check if there is a antenna connection on the operating system (see below). If this is not the case, the remote control CANNOT communicate with the
hydraulic levelling system. In principle, the antenna connector and the antenna are always present when you purchase the levelsystem including a remote
control unit.
If you purchased the remote control at a later stage, then you should remember that this antenna connection on the operating system (main unit) could be
missing.
The presence of the antenna is dependent on the acquisition period the of the levelsystem. After 2013, all operating systems have this antenna connector.
In this case, the dealer/installer can directly connect the antenna to the operating system (the antenna is supplied with the remote control)